Wick & Weigh

No. 09 · Sell

Candle Burn Time Calculator

Burn one candle from the batch for a few hours and weigh it before and after. The calculator turns that into the hours the whole candle will give, and a burn time line you can print without overpromising.

Work it out
Listed jars use CandleScience’s fill weight and width, read October 27 and November 5, 2026.

Your test burn

Jar and all is fine: only the difference counts.
same unitOnce it has cooled.
h

Burn time · from your test

Expected burn timeabout 42 hours
For the labelApprox. 40 hour burn time
Your test
1.2 oz 34 g burned in 8 h = 4.3 g an hour
Which is
6.7 hours per ounce of wax
Wax in the candle
7.9 oz 224 g (listed fill)
Left when you stop at ½ inch
1.64 oz 47 g (2.9 in across)
Burns of 3 hours
about 13

The rate holds only for this wax, wick, fragrance and jar. Change one and test again. The label line rounds down so it never promises more than the candle gives.

wickandweigh.com/candle-burn-time-calculator

Why a test beats a rule of thumb

Ask how long a candle burns and you will find a rule of thumb on almost every candle shop’s blog, and no two agree. The pages we read put it anywhere from 4 to 9 hours per ounce of wax: Mountain City Candles says about 6, Stāndle says 4 to 6 for soy, Kalamazoo Candle works an example at 7, and Small Flame Co gives each wax its own band, with paraffin lowest and beeswax highest. None of them is wrong. They are describing their own wax, wick and jar, and a candle of yours with a different wick can sit at either end. On an 8 oz candle that spread is the difference between 32 and 72 hours, which is far too wide to print.

The good news is that you don’t have to burn a candle to the bottom to find out. Wax burns at a fairly steady rate once the melt pool has formed, so a few hours of burning, weighed before and after, tells you how many grams an hour your candle uses. Divide the wax in the whole candle by that rate and you have its burn time, measured on your candle rather than borrowed from someone else’s.

How to run the test

  1. Take a finished candle from the batch you plan to sell, after the cure time your wax maker recommends, and weigh it. The jar can stay on the scale.
  2. Trim the wick to the length you tell customers to keep it, usually about a quarter inch, and burn it somewhere free of drafts. The National Candle Association suggests about an hour per inch of width per session and no more than four hours.
  3. Blow it out, let it cool completely, and weigh it again. Repeat for a second or third session, trimming the wick each time, and keep a running total of the hours.
  4. Enter the first and last weights and the total hours above.

Two or three sessions matter more than the length of any one of them. The first minutes of each burn go into melting the surface, and the first session of a new candle often runs a little differently from the rest, so a rate taken over several sessions is the steadier one. If you are testing wicks anyway, the wick test planner gives you a burn log with room for the weights.

The wax you never burn

The National Candle Association’s safety advice is to stop burning a candle when half an inch of wax remains, so that last half inch never turns into burn time. In a wide jar it is a surprising amount: in a 3 inch jar it is about 1.75 oz of wax, a quarter of a typical 8 oz candle. The calculator works it out from the jar’s inside width and takes it off before it multiplies, which is why its answer is lower than the wax weight times your rate. A jar with a narrower base than its top leaves a little less, so this errs on the side of a lower number.

Putting a number on the label

Burn time isn’t one of the things the federal label rules ask for, so it is a promise you choose to make. Make it from a test, round it down, and say “approximately”: a candle that beats its label pleases people, and one that falls short brings reviews. The label line from the calculator is rounded to whole hours under 20 and down to a multiple of 5 above that. If your candles vary, test the one you think will burn fastest, and test again whenever you change the wax, the wick, the fragrance or the jar. The net weight line, which the rules do ask for, comes from the label net weight calculator.

Honest limits

The calculator only scales the rate your own test measured. The half inch left in the jar is worked out as a flat disc as wide as the jar, using the same 0.86 wax factor as our other calculators, so treat it as close rather than exact. The rough range is what candle shops publish, not a measurement, and it is there to tell you roughly what to expect, not to print.

Read our guide

How to test a candle's burn time and put an honest number on the labelWeigh a candle before and after a timed burn, take off the wax left at the half inch stop, and round down. A worked 8 oz mason jar example shows where 'Approx. 40 hours' comes from.

Questions makers ask

How long does an 8 oz candle burn?

It depends on the wax, the wick and the jar, so the honest answer is a range. Candle shops quote between 4 and 9 hours per ounce of wax, which for 8 oz of wax is about 32 to 72 hours. A two-session test burn tells you where your own candle falls.

How do I measure a candle’s burn time?

Weigh a cured candle, burn it for a timed session, let it cool and weigh it again. The wax lost divided by the hours is its burn rate. Do it over two or three sessions, then divide the wax in the whole candle by that rate. You don’t need to burn the candle to the end.

Should the burn time on the label be rounded?

Round down. A label that says “approx. 40 hours” on a candle that gives 42 keeps its promise; one that says 45 doesn’t. The calculator rounds to whole hours under 20 and down to a multiple of 5 above that.

Does the whole candle burn?

No. The National Candle Association advises stopping when half an inch of wax remains in a container, so that wax never counts as burn time. The calculator works out how much that is from your jar’s width and takes it off.

Why does my candle burn faster than the calculator says?

Burn rate changes with the wick. A wick that is too large burns hot and fast, an untrimmed wick mushrooms and burns faster still, and drafts speed everything up. Test with the wick trimmed to the length you tell customers to keep it.

Do I need a burn time on a candle label?

The federal label rules ask for net weight, not burn time. Burn time is optional marketing, which is why it should come from a test rather than a guess.

Sources we checked

  1. National Candle Association: candle safety tips (stop at ½ inch of wax)
  2. National Candle Association: how long to burn a candle
  3. Mountain City Candles: soy candle burn times
  4. Stāndle: how long do soy candles burn
  5. Kalamazoo Candle: candle burn time chart
  6. Small Flame Co: which candle wax burns the longest

Numbers last checked 2026-10-21. How we check them. If your supplier says something different, tell us.

Next on the bench

Photo credits: Mustafi Numann · Roman Mesyancev · Allison Saeng · User_Pascal on Unsplash